Mountfield 2135H Manual de instrucciones descargar pdf (Pagina 16)

ENGLISH

4. Clean the paper filter by gently tapping it

against a flat surface. If the filter is very dirty,

change it.

5. Clean the pre-filter. If the filter is very dirty,

change it.

6. Assemble in reverse order.

Do not use compressed air or petroleum based

solvents such as kerosene to clean the paper filter

insert. This will damage the filter.

The paper filter insert must not be oiled.

7.9.2 Air filter (2135H)

The air filter (paper filter) must be cleaned/

replaced after 100 hours of operation.

NOTE! The filters should be cleaned/replaced

more often if the machine operates on dusty

ground.

Remove/install the air filters as follows.

1. Clean carefully around the air filter housing.

2. Dismantle the air filter cover (14:R) by remov-

ing the two screws.

3. Dismantle the paper filter insert (14:S). Make

sure that no dirt gets into the carburettor. Clean

the air filter housing.

4. Clean the paper filter by tapping it gently

against a flat surface. If the filter is very dirty,

replace it.

5. Assemble in the reverse order.

Compressed air or petroleum-based solvents such

as kerosene may not be used for cleaning the paper

filter insert. This will damage the filter.

Do not use compressed air for cleaning the paper

filter insert. The paper filter insert must not be

oiled.

7.10 SPARK PLUG

The spark plug(s) must be replaced every 200

hours of operation (=at every other basic service).

Before disconnecting the spark plug, clean around

its mounting.

Spark plug

: Champion RC12YC or equivalent..

Electrode distance

: 0.75 mm.

7.11 AIR INTAKE (10, 11:P)

The engine is air-cooled. A blocked cooling sys-

tem can damage the engine. Clean the engine’s air

intake after 50 hours of operation. More meticu-

lous cleaning of the cooling system is carried out

during each basic service.

7.12 LUBRICATION

All lubrication points in accordance with the table

below must be lubricated every 25 hours of

operation as well as after every wash.

7.13 FUSES

If any electrical fault occurs, replace the relevant

fuse. The fuse(s) is located together with the

battery under the engine casing.

8 PATENT - DESIGN

REGISTRATION

This machine or parts thereof is covered by the

following patent and design registration:

9900627-2 (SE), SE00/00250 (PCT), 9901091-0

(SE), SE00/00577 (PCT), 9901730-3 (SE), SE00/

00895 (PCT), 9401745-6 (SE), SE95/00525

(PCT), 595 7497 (US), 95920332.4 (EPC).

99 1095 (SE), 499 11 740.9 (DE), M1990 000734

(IT), 577 251-253 (FR), 115325 (US).

9 SERVICE

Authorised service workshops carry out repairs

and guarantee service. They use original spare

parts.

GGP original spare parts and accessories are

designed specifically for GGP machines. Please

note that ‘non-original’ spare parts and

accessories have not been checked or approved

by GGP.

Object Action Fig.

Rear

shaft

3 grease nipples.

Use a grease gun filled with uni-

versal grease. Pump until the

grease emerges.

Steering

cables

Brush the cables clean with a wire

brush.

Lubricate with universal chain

spray.

Tension-

ing arms

Lubricate the bearing points with

an oil can when each control is

activated.

Ideally carried out by two people.

Control

cables

Lubricate the cable ends with an

oil can when each control is acti-

vated.

Must be carried out by two peo-

ple.

Lubricate the deck mount’s lubri-

cating cup using a grease gun until

grease penetrates along side the

axle.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 73 74

Comentarios a estos manuales

Sin comentarios

Mountfield 2135H Manual de instrucciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Tractor Mountfield 2135H