Mountfield 2125H Manual de instrucciones Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
Engine Model:
RV150 and SV150
RV40, V35
Page
18 of 36 Mountfield150cc Selfhelp Guide 2011, Issue 1.0
7 Engine Cutting Out or Running Unevenly
QUICK TROUBLESHOOTING GUIDE:
Problem: Likely Cause: Solution:
Engine hunts
briefly and stops
Fuel cap too tight
Loosen cap (see A)
Engine hunts
continuously
Engine stops
without hunting
and won’t start
again
Dirt in fuel supply
Air drawn into the engine from
a faulty manifold
Faulty spark plug or faulty
spark plug connection
Micro switch not engaging
Faulty coil
Replace fuel (See B)
Refer to dealer
Check for a spark (See
C)
Adjust (see D)
Refer to dealer (see E)
A: The fuel tank on these gravity-fed engines breathes through the thread on the
fuel cap. An air lock may be created if the fuel cap is too tight. Typically, the
engine will not re-start for a period of minutes.
SOLUTION: Remove the fuel cap to let air back into the tank, replace
the cap and tighten it just finger-tight.
NOTE: Air trapped in the carburettor may still stop the engine starting. If so,:
place the mower on a solid surface, or patch of gravel or similar (fuel spillage
may kill the lawn or stain a patio):
1. Remove the spark plug cap (for safety), remove the air filter (for
visibility), tilt the mower BACKWARDS.
2. Viewed from the front, to the left of the spark plug and to the right of
where the air filter was you will see the float bowl on the carburettor.
A bolt holds the bowl in place on the very bottom, but on an angle
slightly closer to you is another bolt with a red washer.
3. With a 10mm spanner undo this bolt until petrol flows freely to bleed
the carburettor of any trapped air. Tighten the bolt once petrol is
flowing freely, replace the spark plug cap and the air filter.
B: With the mower on a solid surface, patch of gravel or similar…..
follow the points above, but in step 3 above REMOVE the bolt (taking care
not to lose the red washer). Allow the petrol to drain completely from the tank
before replacing the nut. Refill the tank with fresh unleaded fuel, and replace
the spark plug cap and air filter.
We advise the engine should be drained of fuel before storage for more
than 30 days. One should only buy fuel in quantities that can be used
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comentarios a estos manuales

Sin comentarios